Technical Interiors Design Process

Our Comprehensive Design/Build Process Delivers Unparalleled Results.

Our unique four-phase design process is based on years of experience producing the finest technical workstation environments for the most complex applications conceivable. If you can imagine it — we can create it.

Design and Layout

We begin each custom design with a careful, and thorough, evaluation of your site, paying special attention to normal, outage, off-normal, startup, and emergency conditions.

Collect information
Define operator relationships
Develop site-specific criteria
Create a schematic control room design
Begin construction of full-scale mock-up (optional)

Detailing for Fabrication

We then use the schematic designs and layouts to fine-tune every detail to precisely meet your unique requirements.

Fine-tune design elevation and sight lines
Fine-tune conferencing and document access needs
Work surface detailing
Verify on-site measurements and equipment placement
Generate 3-D renderings of the completed control room

Fabrication

Because we fabricate your control room ourselves, you can be confident that every component is made with the highest quality craftsmanship. From the 16-guage steel tubing used to fabricate support frames to the Corian® Solid Surface work-surfaces, you can be assured that we use only the highest quality materials.

Workstation support frames
Workstation consoles
Storage components
Workstation surfaces
Storage areas
Raised access flooring system
Colors/finishes

Installation

Due to the complexity of your custom control room, we provide trained Winsted personnel to handle the installation process from start to finish.

Ship the finished components
Unpack and assemble
Install wall, ceiling and lighting treatments (optional)
Install consoles and raised access floor
Provide technical support